One-Zone Ten Source Amplified Connecting Block

Xantech 791-44

The 791-44 is an amplified connecting block that permits any combination of up to ten single or dual IR emitters, driven directly, at high or low output levels. Expandable to 100 emitter ports. Requires either the 781ERGPS or 782ERGPS Power Supply. 

  • Emitter ports with jumpers permit high or low power
  • High-speed opto-isolator for improved operation
  • Parallel emitter ports drive ten single or ten dual emitters
  • Contains red LED input signal Test-IR
  • Up to nine 079000’s can be connected to the 079144 if more than ten emitter ports are needed
  • STATUS terminal for connection of Xantech IR Receivers and Keypads that have status indicator LED’s
  • Quick connect stereo mini jack for Xantech IR Receivers that use a stereo mini plug
Xantech 791-44 Features at a Glance
  • Emitter ports with jumpers permit high or low power
  • High-speed opto-isolator for improved operation
  • Parallel emitter ports drive ten single or ten dual emitters
  • Contains red LED input signal Test-IR
  • Up to nine 079000’s can be connected to the 079144 if more than ten emitter ports are needed
  • STATUS terminal for connection of Xantech IR Receivers and Keypads that have status indicator LED’s
  • Quick connect stereo mini jack for Xantech IR Receivers that use a stereo mini plug
Xantech 791-44 Specifications
Shipping Info
  • Length6.3 (Inches)
  • Width3.1 (Inches)
  • Height1.5 (Inches)
  • Weight0.65 (Lbs)
  • Unit of MeasureEach
  • UPC042777791446
  • Master Pack Qty45
Other Specifications
  • 4-screw plug-in terminal for +12VDC, GND, STATUS, & IR IN.
  • Quick connect "IR RCVR" input (3.5mm mini stereo jack).
  • Red talk-back LED flashes with IR input signal.
  • Ten EMITTER output ports, parallel driven (3.5mm mini mono jacks).
  • HIGH IR OUT port for emitter expansion (3.5mm mini mono jack). See Fig. 5.
  • Use of included jumpers connect either a 100 or a 470-Ohm resistor in series with each emitter jack for high or low power operation.
  • 282/283/284/286 series of Emitters may be used in any combination.
  • Power requirements: 12 volts DC. Uses 781RG or 782-00 Power Supplies (see item 3 below).
  • 2.1 mm coaxial power jack.
  • Dimensions: 6" W x 2-1/4" D x 15/16" H
Xantech 791-44 Warranty

Limited Lifetime Warranty.